Bold reference numbers in this section identify parts not shown in the figures alongside the text, but which can be found in the exploded view diagram.

Refit the seat cover (10) to the seat inserting and tightening the special screws (6) to a tightening torque of 5 Nm ±10%
(Sect. 3 - 3, Frame torque settings).

Refit the seat inserting the front ends of the seat base into the tabs (A) on the tank, then push the rear end of the seat until you hear the screw in the lock click into place.

Remove the seat, as described in the paragraph “Removal of the seat“ of this section.

Release the elastic strap (9) and remove the tool bag (B) and free the ABS diagnosis connector (C) and the ABS diagnosis power supply connector (D) in the ABS version.

Refit the tool tray (4) starting the screws (3) and tighten them to a torque of 5 Nm ±10% (Sect. 3 - 3, Frame torque settings).

Place the tool bag (B) and the ABS diagnosis connector (C) and the ABS diagnosis power supply connector (D) in the tool tray (4) in the ABS version, as shown in the figure.

Refit the seat, as described in the paragraph “Refitting the seat“ of this section.