Bold reference numbers in this section identify parts not shown in the figures alongside the text, but which can be found in the exploded view diagram.

Fit the side stand leg to the bracket and check that there is no excessive clearance. Ensure that the ends of the side stand are not bent with respect to the shank. A side stand which shows signs of cracking must be renewed immediately.

To check the switch (5) refer to Sect. 6 - 6, Checking protection and safety device components.

Grease the side stand leg (1) and fit it to the bracket (3). Secure it with the pivot screw (9) and the nut (10). Tighten the nut (11) to a torque of 20 Nm ±10% (Sect. 3 - 3, Frame torque settings).

Fit the retaining screw (4) and tighten it to a torque of 5 Nm ±10% (Sect. 3 - 3, Frame torque settings).

To place the stand switch wiring refer to the tables (Sect. 6 - 1, Routing of wiring on frame).

Fit the screw (A) in the footrest bracket (C). Tighten the screws (2), (A) and (B) to a torque of 36 Nm ±10% (Sect. 3 - 3, Frame torque settings), following the indicated sequence.