Vehicle pre-delivery

1 -	Vehicle pre-delivery

1	Check the condition of the shipping packaging (if present):

2	Remove from shipping packaging (if present);

3	Check the condition of the motorcycle:

4	Make sure the kit supplied is complete (use the list enclosed to the motorcycle packaging);

5	Installation of the kit supplied, following the instructions enclosed to the vehicle;

6	Only if motorcycle is inside a crate;

7	Installation of accessories according to Customer's order and check if they work;

8	Setting the battery and installation on the vehicle;

9	Check tyre pressure: - Front: 2.25 bar; - Rear: 2.5 bar;

10	Check brake and clutch fluid level (top up, if necessary);

11	Check engine oil level (top up, if necessary);

12	Check if the lights, the turn indicators and the horn are working correctly; Check the height of the headlight beam;

13	Make sure the active and passive keys are working, as well as the steering lock to the right and to the left;

14	Check if the throttle control is working;

15	Check the tightening torque of the front and rear wheel shafts (Front: 63 Nm±5% - Rear LH: 156±5% - Rear RH: 176±5%);

16	Check the tightening torque of the brake calliper retaining screws (Front 45 Nm±5% - Rear 25 Nm±5%);

17	Top-up with fuel until reserve light switching off (approx. 3.5 liters);

18	Make sure that the engine stop switch and the side stand switch are working correctly;

19	Final inspection and road test (check ABS activation, if present);

20	Clean the vehicle;

21	Fill in the on-board documentation (warranty card);