Bold reference numbers in this section identify parts not shown in the figures alongside the text, but which can be found in the exploded view diagram.

Undo the screws (2), remove the rear-view mirrors (1) and recover the washers (4).

Tighten the screws (2) to a torque of 25 Nm ±10% (Sect.  3 - 3, Frame torque settings).

To remove the brackets (5) undo the screws (9), while holding the nuts (6).

On refitting the headlight fairing, always refit the washers (14) in correspondence with the retaining screws (13) to avoid damaging the painted parts and the Plexiglas windshield (10).

Tighten the screws (13) to a torque of 0.2 Nm ± 10%(Sect. 3 - 3, Frame torque settings) while holding the nuts (11).

Fit the brackets (5) to the headlight support, starting the screws (9) and nuts (6).

While holding the nuts (6), tighten the screws (9) (Sect. 3 - 3, Frame torque settings) as follows:

Refit the headlight fairing (8) starting and tightening the screws (7) to a torque of 5 Nm ±10% (Sect. 3 - 3, Frame torque settings).