Bold reference numbers in this section identify parts not shown in the figures alongside the text, but which can be found in the exploded view diagram.

Undo the screws (4) and (11) and remove the RH tank cover (1) and LH tank cover (2) releasing the tabs (A) from the slots (B) in the rear cover (5): recover the nylon washers (10) and the spacers (13).

Remove the front tank cover (3) and recover the spacers (6) and (14).

Tighten the two upper special screws (9) to a torque of 2 Nm ±10% (Sect. 3 - 3, Frame torque settings).

Check that the four bushes (6) are installed on the front tank cover (3) with the larger diameter side facing upwards and the six spacers (14) as shown.

Repeat the above operations to refit the left-hand tank cover (2).

Tighten the screws (7) around the tank plug to a torque of 2 Nm ±10% (Sect. 3 - 3, Frame torque settings).

Tighten the screws (4) and (11) and the remaining special screw (9) to a torque of 2 Nm ±10% (Sect. 3 - 3, Frame torque settings).

Tighten the screws (12) to a torque of 2 Nm ±10% (Sect.  3 - 3, Frame torque settings).